Collection: Latest Products

The Superlux uses two high power Cree LEDs that are run at 700 mA which offers a light level of more than 340 lumens. The low profile design allows for quick and easy surface mounting without causing any obstruction.

This light utilises 6 x 2.5W Power LED’s to create a powerful arc of light and has an IP67 rating offering maximum protection.With a power draw of up to 50% less than standard halogen products and rated life of 60,000 hours.

Unrivalled performance comes from 5 x 1.25 watt Power LEDs, and with the addition of an advanced crater reflector, the Powerlux range is up to 3 times brighter than other LED products on the market giving over430 lux @ 1m. Design of the light is both aesthetic and practical. Power LEDs life expectancy of over 100,000 hours. IP67 rating so ideal for wet environments.

This uses the latest in LED technology, offering optimum performance and extended life, giving greater luminosity, but maintaining low power draw.

Low profile surface mount light unit with high output of 480 lumens (over 260 lux at 1 metre). Waterproof to IP66.

Batten light using a strip of 12 or 24 white LEDs in a waterproof casing. The angled wash of light to the floor makes it a perfect light source to illuminate work areas, shelving, lockers and much more.

• High output LEDs creates a clear safe working environment.
• 70% less energy than Halogen work lights.
• Reduced ‘hotspots’ and lens shadows – no secondary lens is required so fewer
  shadows are present - just pure white light.

This allows the turbine to be electrically isolated from the battery systems whilst also bringing the turbine to a near stop by placing a short circuit across the turbine output by putting the alternator into ‘dynamic braking’ mode. Supplied in a pre-assembled, compact IP65 enclosure making it easy to wire-in and mount.

Rating: 160 watts @ 8m/s (17.8mph) wind
Peak output: 750 watts @ 18m/s (40mph)
Voltage: 12, 24 or 48 volts DC.
Rotor Diameter: 1.54m
Cut In Windspeed: 3m/s (6.7mph)

The Leading Edge LE-300 wind turbine, efficient, compact, quiet and considered to be the most rugged and reliable horizontal axis wind turbine in its class.

Designed for use with LE-300, LE-450 and LE-600 wind turbines, this includes all the equipment needed to construct a guyed mast up to 7.5m – using a standard scaffold pole (48.3mm or 50mm outer diameter) providing a cost effective solution that simply requires a standard scaffold pole that can be sourced locally.

These dump loads are designed to be connected to Morningstar Tristar TS-45 or TS-60 diversion controllers to 'bleed-off' surplus power when batteries are fully charged.

This is a complete guyed tower assembly for the LE-300, LE-450 & LE-600 that is quick and easy to install with a minimal tool requirements.

The electronics within this unit detect the movement of body heat to activate the sensor. Once the sensor has been triggered, this timer unit will automatically switch on for a period of 5 minutes before automatically switching off.

Cost effective switches with a simple easy to install design.

Three and four pole (for three phase) single throw switches lockable in the off position only, mounted in enclosure. Rated: 230/400 Vac.