Battery Storage Accessories

The Victron battery monitors precisely measure the power going in/out of the battery to exactly determine the battery state of charge.

The Victron Smart Battery Shunt is an all in one battery monitor, only without a display. Instead you can connect to it via the VictronConnect App (Available for Android, iOS, Windows, and macOS X) using BlueTooth. From the app you can conveniently read out all monitored battery parameters, like state of charge, time to go, historical information and much more.

The Lynx Shunt VE.Can is an intelligent negative bus-bar 1000A shunt with a positive bus-bar with location for a CNN fuse (not included). A built in battery monitor accurately monitors the state of charge of the battery and sends information via VE.CAN to a Color Control GX for reading out the information and set up.

Changeover switch to enable Fronius GEN24 full backup functionality.

An automatic transfer switch, suitable for the SMA 'Flexible Storage System' which allows operation to continue in case of main power blackouts. Contactors ensure compliant earth switching.

Rolls Batteries AGM Terminal Covers to help prevent the possibility of short circuiting the batteries by insulating the terminal.

Terminal covers protect against accidental contact & possible short circuit.

To fit tapered post battery terminals. Heavy duty with 8mm stud and nut to take crimp terminals.

Used for instance to connect engine starter and service batteries to allow charge from the same alternator, whilst prioritising charge to the starter battery.

These are used to guarantee continuous DC power to mission critical equipment, such as an electronic engine control system. With a diode battery combiner two or more DC power sources can be used in parallel to supply the mission critical load. Failure of one source will not interrupt power to the critical load.

The Victron Battery Protect disconnects the battery from loads before the battery is completely discharged, this prevents damage to the battery and will leave some charge in the battery e.g. to start an engine.

The Cyrix-Li-Charge will connect a battery charger with 3 seconds delay: – if the Charge Disconnect output of the VE.Bus BMS is high, and – if it senses 13,7V (resp. 27,4V or 54,8V) or more on its battery charger connection terminal, and – if it senses 2V or more on its battery terminal (the Cyrix will remain open, if not connect to the battery).

The Cyrix-Li-load will disengage when its control input becomes free floating. If the battery voltage recovers after disconnection (which will happen when no other loads are connected to the battery), the output of the BMS will become high and the Cyrix will reengage after 30 seconds. After 3 attempts to reengage, the Cyrix will remain disengaged until battery voltage has increased to more than 13 V (resp. 26 V or 52 V) during at least 30 seconds (which is a sign that the battery is being recharged).

The Cerbo GX is a flexible communication centre that will take remote monitoring to the next level. With all the hardware connection possibilities to fit your every need.

The Victron Colour Control GX provides control and monitoring for your Victron system through a colourful graphical display.

This device will bring 4G LTE-M connectivity to all VE.Direct enabled devices without any monthly fees or subscriptions, for the first five years.

The Orion-Tr Smart DC-DC charger is a professional DC to DC adaptive 3-stage charger with built-in Bluetooth to allow any Bluetooth enabled smart phone, tablet or other device to be used to monitor, change settings and to update the charger when new software features become available.

The Orion-Tr Smart DC-DC charger is a professional DC to DC adaptive 3-stage charger with built-in Bluetooth to allow any Bluetooth enabled smart phone, tablet or other device to be used to monitor, change settings and to update the charger when new software features become available.

12, 24 and 48 V model DC:DC converters.