-
Inverter Label
It is recommended that Inverters carry a sign stating "Inverter - isolate a.c. and d.c. before carrying out work"
-
IP65 Enclosures with DIN rail
These ergonomically designed, weatherproof, insulated modular enclosures provide the perfect solution to house DIN rail mounted components and are ideal for a multitude of applications
Available in sizes from 12 to 72 ways, all are complete with plexo weatherproof DIN Enclosure, neutral and earth brass terminal bars, and provide IP65 protection. -
Janitza Power Analyser
This DIN rail mounting Power Analyser is a multifunction measurement device and operates as transients recorder, with integrated energy meter (kWh, kVar), harmonics analyser, condition monitoring and data logger. Built-in webserver enables easy access to current and historical data.
-
Kraus & Naimer AC Isolation Switches
Three and four pole (for three phase) single throw switches lockable in the off position only, mounted in enclosure. Rated: 230/400 Vac.
-
Kraus & Naimer DC Isolation Switches
Cost effective switches with a simple easy to install design.
-
Labcraft PIR Motion Sensor Switches
The electronics within this unit detect the movement of body heat to activate the sensor. Once the sensor has been triggered, this timer unit will automatically switch on for a period of 5 minutes before automatically switching off.
-
Leading Edge 9m Guyed Tower
This is a complete guyed tower assembly for the LE-300, LE-450 & LE-600 that is quick and easy to install with a minimal tool requirements.
-
Leading Edge Dump Loads
These dump loads are designed to be connected to Morningstar Tristar TS-45 or TS-60 diversion controllers to 'bleed-off' surplus power when batteries are fully charged.
-
Leading Edge Guyed Tower Kit (up to 7.5m)
Designed for use with LE-300, LE-450 and LE-600 wind turbines, this includes all the equipment needed to construct a guyed mast up to 7.5m – using a standard scaffold pole (48.3mm or 50mm outer diameter) providing a cost effective solution that simply requires a standard scaffold pole that can be sourced locally.
-
Leading Edge LE-300 (Standard) Wind Turbine
The Leading Edge LE-300 wind turbine, efficient, compact, quiet and considered to be the most rugged and reliable horizontal axis wind turbine in its class.
-
Leading Edge LE-600 Wind Turbine
Rating: 160 watts @ 8m/s (17.8mph) wind
Peak output: 750 watts @ 18m/s (40mph)
Voltage: 12, 24 or 48 volts DC.
Rotor Diameter: 1.54m
Cut In Windspeed: 3m/s (6.7mph) -
Leading Edge Run/Stop Switch
This allows the turbine to be electrically isolated from the battery systems whilst also bringing the turbine to a near stop by placing a short circuit across the turbine output by putting the alternator into ‘dynamic braking’ mode. Supplied in a pre-assembled, compact IP65 enclosure making it easy to wire-in and mount.
-
LED Apollo Light
- High output LEDs creates a clear safe working environment.
- 70% less energy than Halogen work lights.
- Reduced ‘hotspots’ and lens shadows – no secondary lens is required so fewer
shadows are present - just pure white light.
-
LED Astro Light
Batten light using a strip of 12 or 24 white LEDs in a waterproof casing. The angled wash of light to the floor makes it a perfect light source to illuminate work areas, shelving, lockers and much more.
-
LED Megalux Enviro Light
Low profile surface mount light unit with high output of 480 lumens (over 260 lux at 1 metre). Waterproof to IP66.
*see manufacturer's documentation for further information