-
Lorentz S1-200 Dry Run Protection Sensor
Optional well probe to add dry run protection to Lorentz S1-200 pumps, includes 15m cable.
-
Lorentz S1-200 Extension Cables
Extension cables with plugs and sockets used to extend motor cable or cables for dry run protection sensor or tank full float switch.
-
Lorentz S1-200 Self Install Pump System
Designed and built using LORENTZ's 25 years experience in off -grid water pumping systems. The system sets a new level of quality and reliability for plug and play pumping systems.
-
Lorentz S1-200 Tank Full Float Switch
Optional float switch for use with Lorentz S1-200 pumps, includes 10m cable.
-
Lorentz Sun Sensor Module
The LORENTZ Sun Sensor module and software allow the PS2 controller to accurately estimate irradiation levels and control the pump based on this.
-
Lorentz Well Probe
Used for dry run protection in applications with LORENTZ Solar Pump Systems. The switch can be used to detect the water level within a well. When the water level in the well drops below the level of the well probe, the LORENTZ Controller will stop the pump and indicate Source Low.
-
Made-Up Cables
These cables have a male connector on one end and a female connector on the other. They can be used to extend PV module output cables or cut to provide a male & female cable from module to junction box.
-
Manual Backup Switch for Fronius GEN24
Changeover switch to enable Fronius GEN24 full backup functionality.
-
Marlec iBoost 5m Extension for Sender/Clamp
This 5m extension for Solar iBoost+ allows extension of the cable between the sender and the clamp sensor. This can be useful in properties with thick walls where moving the sender to the other side of a wall will help ensure good signal strength between the Solar iBoost+ and the sender.
-
Marlec iBoost Buddy
The Marlec iBoost Buddy enables remote monitoring and boost control of the Solar iBoost+ immersion controller.
-
Marlec Solar iBoost+
The Marlec Solar iBoost+ automatically diverts excess solar generation (normally exported to the grid) to an immersion heater saving money on water heating costs, reducing use of the boiler and increasing self-consumption of free solar energy.
-
MC4 Connector Sealing Cover
MC4 sealing covers are used to protect the connectors from water and dust ingress. It is particularly important to use sealing covers during installation when the connectors are left disconnected and exposed to the elements. MC4 connectors that have been exposed to moisture may suffer internal corrosion which can cause increased resistance and earth leakage issues.
*see manufacturer's documentation for further information